Actron GM Code Scanner CP9001 Uživatelský manuál Strana 66

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 98
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 65
66
Reading ABS Codes:
Bosch 2U (Version B)
IMPORTANT: Perform all steps in
PRE-DIAGNOSTIC VISUAL INSPEC-
TION and FUNCTIONAL CHECK
before reading ABS codes!
1) Take Safety Precautions
• Set parking brake, block drive
wheels.
• Put shift lever in PARK (automatic
transmission) or NEUTRAL
(manual transmission).
• Make sure ignition key is in OFF
position.
2) Have a Pencil and Paper Ready
This is for writing down all the codes.
3)
Find the Computer Test Connector
• Service manuals call this
connector the Assembly Line
Diagnostic Link (ALDL) connector.
It may also be called the Assembly
Line Communication Link (ALCL)
or simply test connector.
• The connector is located under the
dashboard on the driver’s side.
• The connector may be in full view,
or it may be recessed behind a
panel opening.
• The connector
may have a
slip-on cover
labeled
“Diagnostic
Connector.” Remove cover for
testing. Replace cover after
testing. Some vehicles require this
cover in place for
proper operation.
4) Verify Ignition
Key is OFF
O
F
F
O
N
O
F
F
O
N
TEST
ABS
ENGINE
T
M
GM 1982 & higher - CP 9001
C
ar Co
m
pu
ter Co
de Reader
5) Put the TEST switch on ABS
6) Plug the Code Scanner into the
test connector
• The Code Scanner only fits ONE
WAY into the test connector.
• The Code Scanner
will not harm
the vehicle computer.
Note: The Code Scanner does not
use all of the test connector
contacts. This is normal.
7) Turn Ignition Key
to ON Position
but DO NOT
START THE
ENGINE
WARNING: Stay away from the
radiator cooling fan! It may turn on.
8) Get Codes from
the Flashing
“Anti-Lock” Light
Count flashes to get trouble codes.
(Flashes begin after a few seconds.)
Code 12 looks like:
PAUSE
❊❊
FLASH (pause) FLASH FLASH
(FLASH = 1, FLASH FLASH = 2.
Put 1 and 2 together = code 12.)
Code 23 looks like:
❊❊
PAUSE
❊❊❊
FLASH FLASH (pause)
FLASH FLASH FLASH
Each code is flashed three (3) times
before the next trouble code is sent.
After all codes are sent, the whole
sequence is repeated. This
continues until the ignition key is
turned OFF (so you can double
check your code list).
Zobrazit stránku 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 97 98

Komentáře k této Příručce

Žádné komentáře